Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Intercooler

Pages: [1] 2 3 ... 506
10mm semi-auto handguns / Re: Sig 220 legion VS Stock 1
« on: Today at 02:25:59 AM »
  Yea. When you shoot both, does one have a better feel to it?

10mm semi-auto handguns / Re: Recoil spring for Stock 2
« on: February 18, 2018, 03:43:26 PM »
  I would take it apart and try assembling again. I seem to recall an issue similar to this at some point.

10mm semi-auto handguns / Re: Sig 220 legion VS Stock 1
« on: February 18, 2018, 02:52:21 PM »
The Stock I even has the bigger cone (bull) barrel in it. You will run out of ammo money shooting Underwood before breaking it! I haven't busted one of mine yet  8) More capacity and lighter  ;)

10mm semi-auto handguns / Re: Recoil spring for Stock 2
« on: February 18, 2018, 02:47:24 PM »
Hmmm... What part number does the bag say?

I see these two:
X   49820   
X   49722   

In the Longslide version they don't offer a 22lb. Maybe the 4.5" pistols take Fullsize?

10mm semi-auto handguns / Re: Recoil spring for Stock 2
« on: February 18, 2018, 10:50:32 AM »
 Don't they offer a shorter one for the non-longslide version?

10mm semi-auto handguns / Re: IFG Tanfoglio 6" Bullseye 10mm
« on: February 17, 2018, 02:06:06 AM »

While I am not allowed to specifically say exactly what new models are being imported because it is not 100% finalized, I can tell you that in addition to the two new models revealed at SHOT they said that at least three more models will be imported this year, and there will be something to hopefully make most everyone happy.  At least one of the models will be large frame possibly two, with the addition of another small frame.  I will add more info when I’m allowed to and don’t forget if there are specific models you are hoping to have imported contact Tanfoglio directly and tell them you want IFG to import it.  It is working so far and Mossimo and Mateo are getting the message.

Keep pounding!

10mm semi-auto handguns / Re: Grand Power P40L range video
« on: February 16, 2018, 06:11:04 AM »
I see the sales representative was doing damage cotrol in the video comments.

I didn't notice a flash like before. Possibly not #9? I don't know if these GS were bonded, but the originals did really well in gel.

Gunsmithing / Re: Grand Power K100 sights installed
« on: February 15, 2018, 11:29:29 AM »
  Finally! I swapped to a Dawson rear sight and then went back to the stock front pieces that come in 1, 0, -1 and the 0 worked. It sits at .135" tall, so just need to order the right size CZ front and fit it. It was dead on today!

Gunsmithing / Re: Kensight adjustable install on EAA Hunter
« on: February 15, 2018, 11:25:55 AM »
Today I had the adjustment after drifting the sight over. So far so good!

You might want to go with a shorter front so you can keep the rear sight cranked down instead of elevated. It holds better that way.

Finally! I'm glad to finally get a break in the weather to get these done. They proved to be stronger as expected and I will get these to The Shadow for pull-downs.

155gr Gold Dot
EAA Limited Pro 4.75" 1480, 1459 Average 1469.5 FPS/ 743 LBS
EAA Super Match 6" 1548, 1527 Average 1537.5 FPS/ 814 LBS

165gr Golden Saber
EAA Limited Pro 4.75" 1394, 1404 Average 1399 FPS/ 717 LBS
EAA Super Match 6" 1462, 1434 Average 1448 FPS/ 768 LBS

200gr Hardcast
EAA Limited Pro 4.75" 1234, 1242 Average 1238 FPS/ 681 LBS
EAA Super Match 6" 1260, 1267 Average 1263.5 FPS/ 709 LBS

Any of them will work, but Dawson is best.

The weather has been horrible. It's supposed to rain this evening again, but tomorrow shows 51 and sunny. I'm going for it tomorrow evening.

Factory 10mm ammo / Re: Reeds 10mm Reduced Recoil Ammo
« on: February 14, 2018, 01:24:07 AM »
It's all outstanding.  This should be the same and give what's stated.

Pages: [1] 2 3 ... 506